JD series a UV curable, HDDA- free, NVP – free, screen ink for Compact discs as like CDR, DVD, DVD-R. This is specifically formulated not only amin-free with non harmful material , but fast curing performance, but also optimized at a rheology which minimizes ink flow at set up and pause in printing, while maintaining printability at high –speed produ ction rate. JD inks has outstanding adhesion to both UV spin-coated surface and uncoated polycarbonate disc. It is utmost low shrinkage when radiation curing so that give excellent printing on DVD decoration.

A screen mesh size of 355 – 460 mesh/inch plain wave, monofilament polyester mesh will be provide best results and sharp polyurethane squeegee of approximately 75 – 85 durometer 60/90 recommended for optimum results. Typical printing lines utilize 300W/inch(120W/cm)D-bulbs, between print stations. Other UV systems with suitable spectral output in the 300-400nm range, such as medium -pressure mercury vapor or metal halide, may be used. Actual cure speeds will vary depending on color and opacity of the ink, screen mesh, and other printing parameters that affect ink deposit, as well as the UV curing unit used.

Screen may be cleaned with IPA, n-propyl acetate or many commercial screen washes. We recommended JD-100 Wash up solution for cleanings and clean immediately after printing.

As with this inks , gloves and safety device should be used when handling the products. For more complete information do you need, refer to the Material Safety Data Sheet before use.

The product requires stirring prior to use. The shelf – life is good when stored away from heat and protected from UV light exposure. The material is combustible and should not be used near open flame. Store below 32°C. Best when u sed within 6months of product Lot No. date on label. Under different conditions, particular higher storage temperatures, the shelf life is reduced.

All information on this data sheet is based on JESCO laboratory test and experience in print press. Procedures and directions for use of JESCO products must be considered as recommendations only, with no warranties expressed or implied. The printer solely responsible for determining suitability of any JESCO product for the particular application.