JST series, a UV curable screen ink, was designed for use on Stainless, Aluminum and Metals. There is no additives required and excellent rub-resistance and chemical resistance with good gloss, wide finishes & color in the fast curing properties. Weatherability is subject to condition of use. Consults the technical department to use information regarding weather resistance and weatherable application of JST series inks.

A screen mesh size of 200 – 300 mesh/inch plain wave, monofilament polyester mesh will be provide best results and sharp polyurethane squeegee of approximately 75 – 85 durometer 60/90 recommended for optimum results. Typical printing lines utilize 300W/inch(120W/cm)D-bulbs, between print stations. Other UV systems with suitable spectral output in the 300-400nm range, such as medium-pressure mercury vapor or metal halide, may be used. Actual cure speeds will vary depending on color and opacity of the ink, screen mesh, and other printing parameters that affect ink deposit, as well as the UV curing unit used. Before printing by it, check surface tension of substrate for good adhesion. Since all the print substrates mentioned may be different in printability, even within an individual type, preliminary trials are essential to determine suitability for the intended use.

Screen may be cleaned with IPA and some Alcohols, n-propyl acetate or many commercial screenwashes. We recommended JO – 100 Wash up solution for cleanings and clean immediately after printing.

As with this inks, gloves and safety device should be used when handling the products. For more complete information do you need, refer to the Material Safety Data Sheet before use.

The product requires stirring prior to use. The shelf life is good when stored away from heat and protected from UV LIGHT exposure. The material is combustible and should not be used near open flame. Store below 32℃. Best when used within 6 month of product Lot No. date on label. Under different conditions, particular higher temperatures, the shelf life is reduced.

We are on preparing this colors for any enquiry.

All information on this data sheet is based on JESCO laboratory test experience in print press. Procedures and directions for use of JESCO products must be considered as recommendations only, with no warranties expressed or implied . The printer solely responsible for determining suitability for any JESCO product for he particular application.