ITO311Coating is, a UV curable screen printable, transparent dielectric coating for dot spacer on 170 sputtered polyester film. This is specifically formul ated not only outstanding adhesion to metal or glass substrates but also viscosity is optimized at a rheology which achieving dots of heights and narrow diameter.

A screen mesh size of 200 – 300 mesh/inch plain wave, monofilament polyester mesh will be provide best results and sharp polyurethane squeegee of approximately 75 – 85 durometer 60/90 recommended for optimum results. Typical printing lines utilize 300W/inch(120W/cm)D-bulbs, between print stations. Other UV systems with suitable spectral output in the 300-400nm range, such as medium-pressure mercury vapor or metal halide, may be used.

Screen may be cleaned with IPA, n-propyl acetate or many commercial screen washes. We recommended JD-100 Wash up solution for cleanings and clean immediately after printing.

As with this inks, gloves and safety device should be used when handling the products. For more complete information do you need, refer to the Material Safety Data Sheet before use.

The product requires stirring prior to use. The shelf – life is good when stored away from heat and protected from UV light exposure. The material is combustible and should not be used near open flame. Store below 32°C. Best when used within 6months of product Lot No. date on label. Under different conditions, particular higher storage temperatures, the shelf life is reduced.

All information on this data sheet is based on JESCO laboratory test and experience in print press. Procedures and directions for use of JESCO products must be considered as recommendations only, with no warranties expressed or implied. The printer solely responsible for determining suitability of any JESCO product for the particular application.