SPET series inks is, essentially evaporation-drying ink, screen inks for on pretreated PE and PET films as well as garment printings. It has excellent adhesion, chemical resistance and has lightfast properties. This inks contain specified color that Hologram inks, Glitter ink, Pearl inks.

SPET series is formulated low odor solvent and good stability on the screen, A screen mesh size of 250 mesh/inch plain wave, monofilament polyester mesh will be provide best results and sharp polyurethane squeegee of approximately 75 – 85 durometer 60/90 recommended for optimum results. Inks are supplied at print ready viscosity f or most applications. However can be add 15 ~ 20% of reducer if need viscosity control.

Screen may be cleaned with Cyclohexanon, Xylene or many commercial screen washes. We recommended JD-100 Wash up solution for cleanings and clean immediately after printing.

As with this inks, gloves and safety device should be used when handling the products. For more complete information do you need, refer to the Material Safety Data Sheet before use.

The product requires stirring prior to use. The shelf – life is good when stored away from heat and protected from UV light exposure. The material is combustible and should not be used near open flame. Store below 32°C. Best when used within 6months of product Lot No. date on label. Under different conditions, particular higher storage temperatures, the shelf life is reduced.

All information on this data sheet is based on JESCO laboratory test and experience in print press. Procedures and directions for use of JESCO products must be considered as recommendations only, with no warranties expressed or implied. The printer solely responsible for determining suitability of any JESCO product for the particular application.