
SPECIFICATION

DESCRIPTION
SWR series inks is, essentially evaporation-drying ink, screen inks for on glass and high transparence plastics, high reflective materials. It create special appearance as
like to patterned surface which irregularity, wave, earthquake. Since formulated with special raw material for foiled paper and glass, it provides monstrous figuration so that replace etching effect.

APPLICATION SUGGESTIONS
SWR series is formulated low odor solvent and good stability on the screen, A screen mesh size of 100 ~ 300
mesh/inch plain wave, monofilament polyester mesh will be provide best results and sharp polyurethane squeegee of approximately
75 – 85 durometer 60/90 recommended for optimum results. Inks are supplied at print ready v
iscosity for most applications. However can be add 5 ~ 10% of reducer if need viscosity control.

WASH UP
Screen may be cleaned with Cyclohexanon, Xylene or many commercial screen washes. We recommended JD-100 Wash up solution for cleanings and clean immediately after printing.

HEALTH & SAFETY
As with this inks, gloves and safety device should be used when handling the products. For more complete information do you need, refer to the Material Safety Data Sheet before use.

STORAGE & HANDLING
본The product requires stirring prior to use. The shelf – life is good when stored away from heat and protected from UV light exposure. The material is combustible and should not be used near open flame. Store below 32°C. Best when used within 6months of product Lot No. date on label. Under different conditions, particular higher storage temperatures, the shelf life is reduced.

DISCLAIMER
All information on this data sheet is based on JESCO laboratory test and experience in print press. Procedures and directions for use of JESCO products must be considered as recommendations only, with no warranties expressed or implied. The printer solely responsible for determining suitability of any JESCO product for the particular application.