
SPECIFICATION

DESCRIPTION
WR series is UV screen inks for create special appearance as like to patterned surface which
irregularity , wave, earth-quake. In case of WR 1012 coatings is not necessary previous special IR
lamp before UV curing, but only conventional UV lamp. Since formulated with special raw
material for foiled paper and glass, it provide monstrous figuration so that replace etching effect

APPLICATION SUGGESTIONS
A screen mesh size of 80 – 100 mesh/inch plain wave, monofilament polyester
mesh will be provide best results and sharp polyurethane squeegee of approximately
75 – 85 durometer 60/90 recommended for optimum results. Actual cure speeds will vary
depending on color and opacityof the ink, screen mesh, and other printing parameters that affect ink deposit, as well as the UV curing unit used.
WR1012 Coatings |
use wavelength |
300 – 400 nm ---- 1 – 2 pass |
27m/min |
WR1013 Coatings |
use wavelength |
200nm ----- 1 pass |
13m / min |

WASH UP
Screen may be cleaned with IPA and some Alcohols, n-propyl acetate or many
commercial screenwashes.
We recommended JO – 100 Wash up solution for cleanings and clean immediately
after printing.

HEALTH & SAFETY
As with this inks, gloves and safety device should be used when handling the products. For more
complete information do you need, refer to the Material Safety Data Sheet before use.

STORAGE & HANDLING
The product requires stirring prior to use. The shelf life is good when stored away from heat and
protected from UV LIGHT exposure. The material is combustible and should not be used near open
flame. Store below 32℃. Best when used within 6 month of product Lot No. date on label. Under
different conditions, particular higher temperatures, the shelf life is reduced.

MONOPIGMENTED COLORS :
We are on preparing this product for enquiry.

PANTONE METALLIC COLORS :
We are on preparing this colors for any enquiry.

BLACK & WHITE :
We are on preparing this colors for any enquiry.

SWOP PROCESS COLORS :
We are on preparing this colors for any enquiry.

MODIFIER & OTHER PRODUCTS :
We are on preparing this colors for any enquiry.

WASH UP SOLUTION :
JO- 100 low toxic cleaning solution

DISCLAIMER
All information on this data sheet is based on JESCO laboratory test experience in print press.
Procedures and directions for use of JESCO products must be considered as recommendations only, with
no warranties expressed or implied . The printer solely responsible for determining
suitability for any JESCO product for he particular application.